Waterborne polish formulated for use on commercially maintained hardwood floors Self-dissolving when used with a buffer and white polishing pad Buffable - refreshes the surface without additional coating Cleans up with warm soapy water

• Formulated for use on Bona finishes and/or other urethane finish types
• May be buffed to remove scuffs and renew the luster
• Does not mar like wax
• Does not waterspot like wax
• Helps remove hairline scratches on hardwood floors
• Volatile Organic Component (VOC) content does not exceed 400 grams/liter
• Premixed - use directly from container

• Commercially maintained hardwood floors
• Use on ceramic tile, vinyl to improve luster
• Ideal for bathrooms and kitchens

NOTE: The frequency of maintaining your wood floors with SWEDISH FORMULA LUSTER COAT depends upon the amount of traffic and severity of use. For best results on most commercial floors, spray-buff LUSTER COAT once per week as follows:

INITIAL APPLICATION:
1. Make certain your floor is clean from foreign materials or residues by thoroughly sweeping or vacuuming.
2. Clean the floor with PACIFIC FLOOR CLEAN. Follow the instructions on PACIFIC FLOOR CLEAN LABEL for dilution ratio based on severity of cleaning required. Light to medium cleaning required dilute (1:8), for deep cleaning dilute (1:5)
3. Apply initial application of LUSTER COAT using a new, clean sponge applicator. Apply thin; coverage should approximately 4,000 square feet per gallon.

DRY TIME:
LUSTER COAT will dry to a beautiful shine in about one hour. Allow to dry prior to allowing normal traffic.

REAPPLICATION:
Once you have a layer of  LUSTER COAT on your floor, all future applications should be done as a spray-buff method with a low- or variable-speed buffer and a white pad. 1. Follow instructions 1 & 2 under INITIAL APPLICATION. 2. Mist the surface of the floor with LUSTER COAT and, using s white pad, allow the buffer to work across the surface of the floor. Clean or replace the white pad as necessary.
NOTE: Although LUSTER COAT will dry to a high sheen, a higher sheen may be achieved by using a Bona Conditioning Pad with the  buffer.

FINISH RECOATING:
LUSTER COAT must be completely removed by sanding to bare wood prior to recoating with finish to ensure proper adhesion.

CLEAN-UP:
Clean all tools and equipment with water.

Ingredients - Acrylic and wax resin in water
Color - Milky white (wet), colorless (dry)
Odor - Non-offending
Clarity - Clear when dry
Solids - 11%
pH - 7.8%
Viscosity - (#4 Ford cup @ 25° C) 11 - 12 sec.
Flash Point - >200° F
Density - 8.42 lbs./gallon (1.01 S.G.)
Stability - 1 year shelf life
Leveling - Excellent
Defoaming - Excellent
Drying Time - 1 hour
Percent Cured after 24 hours - 90%
Maximum Cure - 100% after one week
Gloss Level - (60°) >85 when burnished w/high speed buffer
Coverage - 4,000 square feet per gallon
VOC - Does not exceed 400 grams per liter (3.3 lbs. per gallon)

• 1 gallon plastic bottle
• 5 gallon plastic pail